Ceiling Fan Light Pull Chain Stuck

The switch will also need to be replaced if the chain will not pull down or if it broke off inside the fan housing.

Ceiling fan light pull chain stuck.

Pull chain switches for light fixtures and ceiling fans can become a problem over time due to internal worn out parts a broken pull chain and in some cases the pull chain switch contacts may just wear out and stop working. Avoid pulling on the chain using a lot of force because this is often how it breaks. 1st click high. Turn off the power to the fan using the circuit breaker box.

Most fans have the same click pattern. How to repair pull chain light switch in ceiling fan. Light is off and i need it badly. The first thing i would do in a situation like this is to consider replacing the pull chain light switch.

If the fan is connected directly to power not controlled by a wall switch you ll probably want to shut off the breaker to stop the fan while you do this so you don t loose your head. Also the light switch itself may wear out or fail. Fan is working by switch and chain but light chain won t pull to turn on light. Remove the screws holding the fan s outer cover in place.

Flip the power switch in the room if necessary to turn the fan on. The ceiling fan has a wall switch and drop down chains to turn fan on off also light chain. If even a small bit of the chain is left you may be able to pull it using needle nose pliers. If you pull too hard on the pull chain the chain can break or come out of its socket.

Set it aside. Replace the old switch with a new pull chain switch then place the end cap back onto the light fixture. All you need is wd40 spray inside switch it should work for light switch aswell if it dont work for you then need switch replaced im not doing this to get su. Now that your ceiling fan pull chain switch is fully installed pull on it gently to see if it works.

If the lights come on or the fan starts to rotate it s all fixed. If your ceiling fan or the light on the fan doesn t work when the chain is pulled then the problem is most likely a broken fan pull chain switch. Wrap electrician s tape around the exposed wire ends and push them back into the fixture. Unscrew the nut holding the pull switch in place.

Carefully reattach the wires from the switch to the light remembering to pair black to black and ground to ground. Remove the cover and set it and the screws aside. These pull chains get pulled on daily and can be broken.